Description
HIGH HEAD EFFLUENT PUMP: designed to handle higher-head flow for transferring gray water from deep effluent systems and sump systems; 3/4″ solids handling; 60' shut-off
HIGH EFFICIENCY MOTOR: Permanent Split Capacitor (PSC) thermally protected motor runs on 9 Amps, 1030 Watts and is cCSAus listed; rated for continuous duty
BUILT TO LAST: Epoxy-coated cast iron motor housing, and volute; Nitrile carbon/ceramic shaft seal; thermoplastic elastomer non-clog impeller; steel shaft; upper and lower ball bearings
MANUAL EFFLUENT PUMP: designed to work with piggy-back tethered or vertical switches (sold separately); 30' 115-volt cord with 3-prong plug included
SPECIFICATIONS: 115-volts, 1/2 hp, 60 Hz, 9 running Amps, 1030 Watts, 3600 GPH at 5' lift; 60' shut-off; 26 PSI; 1-1/2″ FNPT discharge; rated for 140 °F liquid temperature; 30' cord; 39 lbs.
With a 60' shut-off the 10-ECH series is built to handle higher-head flow in residential wastewater removal, dewatering, and water transfer applications, the 10ECH series of effluent pump is a homeowner's trusted companion. Constructed of heavy cast iron with an epoxy-coated finish and stainless steel fasteners, the 10ECH series of effluent pumps will provide years of reliability. Ideally suited for effluent septic systems with deep tanks. This 1/2 HP pump delivers up to 3600 GPH and comes with a 30' cord, 3-prong plug. This is a manual pump (switch not included) and is designed to work with a piggyback switch, or controller (not included.)
Features & Benefits:
– 1/2 hp Permanent Split Capacitor (PSC) motor
– Designed for continuous duty
– Energy-saving low amp draw
– 1-1/2″ FNPT discharge
3/4″ solids handling
Reviews
There are no reviews yet.